Installation
CPU circuit board switch settings
Set switches SW1, SW2 and SW3 on the CPU circuit board as follows.
SW2 |
SW1 |
SW3 |
SW1 (Selector switch for landing characteristics)
For a soft landing: | Set SW1 to the left position (RP501). (Factory setting) |
For an exact landing: | Set SW1 to the right position (RP605). |
SW2
Do not change the position of this switch. Continue to use it at the DESK TOP position.
SW3
Do not change the position of this switch. Continue to use it at the
•Before setting these switches, be absolutely sure to turn off the power of the AC adapter connected to the pan/tilt head.
•The switch settings are not changed simply by changing the position of the switches.
After changing the position of a switch, turn the power off and then back on to actually change the setting of that switch.
16
