Indoor Pan/Tilt Head
Parts and their function
@ | C |
|
A | D | G |
| ||
|
| H |
B | E | I |
| F |
|
Rotary head connector panel |
| J |
K
L
M
N
O
P
Pedestal connector panel
1Rotary head | :Pan/tilt head mounting holes |
This rotates in the horizontal direction.
These four holes are used when installing the pan/tilt head.
2Pedestal
3POWER ON/OFF switch
When this is set to ON, the unit’s power is turned on; when it is set to OFF, it is turned off.
4AC 120 inlet [AC IN] (AC 3-point inlet)
Connect the accessory AC power cable to this inlet.
;Bottom panel
<PROMPTER connector
The prompter is connected to this connector.
The maximum current which can be supplied from the DC 12V OUT socket is 2A.
When the prompter is connected, the pan/tilt head’s speed is reduced to about
5Camera mounting base mounting screws
M5!22 mm hexagon socket head screws, M5 flat washers (3 of each provided as accessories)
These parts are used to secure the camera mounting base to the rotary arm.
6Tally lamp (accessory)
This is lighted up red by the selected signals.
7Rotary arm mounting screws
M5!22 mm hexagon socket head screws, M5 flat washers (4 of each provided as accessories)
These parts are used to secure the rotary arm to the rotary head.
8Rotary arm
This rotates in the vertical direction.
9Camera mounting base
Mount the convertible camera on this base.
87654321
?>=<;:9
Pin layout as seen facing the
prompter connector
Pin No. | Signal Name | |
1 |
| – – – |
|
|
|
| 9 | – – – |
|
|
|
2 |
| PROMPTER VIDEO |
|
|
|
| 10 | PROMPTER VIDEO GND |
|
|
|
3 |
| – – – |
|
|
|
| 11 | – – – |
4 |
| DC 12V OUT |
| 12 | – – – |
5 |
| GND |
|
|
|
| 13 | – – – |
|
|
|
6 |
| – – – |
|
|
|
| 14 | DETECT |
|
|
|
7 |
| – – – |
|
|
|
| 15 | GND |
|
|
|
8 |
| – – – |
9
