Panasonic AW-PH400P manual $ Setting the mounting direction switch, For stand-alone installation

Indoor Pan/Tilt Head AW-PH400

Installation (Be sure to ask your dealer to install the unit.)

$ Setting the mounting direction switch

Set the switch as follows when the unit is to be installed on the ceiling. (This switch was set to the stand-alone installation position at the factory.)

1Remove the four screws, and gently remove the pedestal connector panel.

2Set switch S1 on the PCB inside the pan/tilt head as follows.

For stand-alone installation:

Set S1 to the rear position (T). (Factory setting)

For installation on the ceiling:

Set S1 to the front position (H).

3Upon completion of the setting, return the pedestal connector panel to its original position, and attach it using the screws. (Take care not to pinch or disconnect the wires.)

Rear position (T) for stand-alone installation

S1

S2

Front position (H) for installation on the ceiling

S1

Pedestal connector panel

≥Be absolutely sure to turn off the power before changing the position of this switch.

14