25
Touchscreen

Configuring the Touchscreen

When needed, the touchscreen can be configured using the following step s.
1Display [Mouse Properties] screen.
Select on the taskbar and then select [TouchScreen] or select [TouchScreen] in
[start] - [Control Panel] - [Printers and Other Hardware] - [Mouse].
A. Double click settings
Set the width and height of the double click.
B. Advanced Configuration
Set the advanced settings.
C. Test
Test for the "Double click settings".
D. Calibration & Test
Define the calibration setup. Use this procedure when the cursor, the stylus
(included) touches do not appear to agree. (Calibration must be performed when
the display resolution has been changed.)
Touch the "+" mark on the calibration screen for about one second.
After the calibration procedure is executed (e.g., after the nine "+" marks are
touched), the procedure ends when
Enter
is pressed.
2Make necessary changes and select [OK].
NOTE
The double-click speed of the touchscreen can be changed in [Tap and Buttons].
Rotates the display to [0 degrees] before performing the calibration. (page 33)
For more information, click at the upper right corner.