![](/images/new-backgrounds/1264023/26402383x1.webp)
9.2.14. Setting the Speaker and the LED PCB
1.Fix the LED PCB using the two Screws<N9>.
2.Set the Speaker L and R to the computer.
3.Connect the Speaker Cable L and R to the two Connec- tors (CN1002, CN1003) on the LED PCB.
4.Fix the Speaker Cable L and R using the Tape.
5.Fix the Speaker L and R using the Speaker Holder.
Note:
Ensure the three Hooks of the Speaker Holder are securely set in the computer.
Screws <N9>: DFHE5025XA
QSoldering the Speaker Cable and Setting the Speaker Rubber
CN1002 | <N9> | |
| ||
Tape | CN1003 | |
LED PCB | ||
Speaker | ||
| ||
Holder | Tape | |
Speaker L |
| |
| Speaker | |
| Holder | |
| Speaker R |
Speaker | Speaker Rubber |
|
|
| Red Line |
Soldering | Soldering |
|
|
|
|
| |
White Line | Red Line | Speaker | White Line |
| Speaker Cable |
| Speaker Cable |
QCautions for Setting the Speaker
Safety Working
Tape
Speaker
Holder
Speaker L
Pass the Speaker Cables through the notch. (Avoid running over.)
Set as the loop of the Speaker Cable is on the upper side.
Tape
Speaker
Holder
Speaker R
Fit to the stand wall.
SP Conductive | SP Conductive | |
Cloth R | ||
Cloth L | ||
Fit to | ||
| ||
| the corner. | |
Speaker L | Speaker R |
Ensure the Cable does not touch the Steel Plate.
Securely attach the SP Conductive Cloth to the round frame of the Speaker.
Ensure the Hooks are securely set in. (3 points)
Pass the Speaker Cables through the notch. (Avoid running over.)