CQ-5100U 19
Sound skips due to
vibration.
Mounting angle is over 30˚.
aAdjust mounting angle to less than 30˚.
Instable mounting.
aMount the unit securely with the mounting parts, referring to the
section on installation.
Much noise in FM stereo
and monaural broad-
casts.
Trouble
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
The radio antenna is not extended enough.
aExtend fully the radio antenna.
Preset station is reset. Battery cable is not correctly connected.
aConnect the battery cable to the terminal that is always active.
Check point
❐Radio
Disc is in the CD
compartment but no
sound is made, or disc is
ejected automatically.
Trouble
Disc is upside down.
aPlace disc in the correct direction with the label side up.
Sound skips, bad sound
quality. (e.g. caused by
noise)
• Disc is dirty.
• Disc has scratches.
aClean disc, referring to the section on “Notes on Discs”.
aThe unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.
• Disc is dirty.
• Disc has scratches.
aClean disc, referring to the section on “Notes on Discs”.
A disc that has data other than CD-DA type is loaded.
aDiscs that have CD-DA type data should be used.
aThe unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.
Check point