E N G L I

Troubleshooting (continued)

S

H

35

CD

Problem

Disc is in the CD com- partment but no sound is made, or disc is ejected automatically.

Sound skips, bad sound quality. (e.g. caused by noise)

Sound skip due to vibration.

Disc is not ejected.

Possible cause / Possible solution

Disc is upside down.

aPlace disc in the correct direction with the label side up.

Disc is dirty.

aClean disc, referring to the section on “Notes on CD / CD Media (CD-R, CD-RW)” (a Page 35).

A disc that has data other than CD-DA type is loaded.

aDiscs that have CD-DA type data should be used.

aSome CD-R/RWs cannot be played back successfully thanks to incompatibility among writing software, a CD recorder (CD-R/RW drive) and the discs. Refer to instructions for the concerned devices for details.

Disc is dirty.

aClean disc, referring to the section on “Notes on CD / CD Media (CD-R, CD-RW)” (a Page 35).

aSome CD-R/RWs cannot be played back successfully thanks to incompatibility among writing software, a CD recorder (CD-R/RW drive) and the discs. Refer to instructions for the concerned devices for details.

Mounting angle is over 30 degrees.

aAdjust mounting angle to less than 30 degrees.

Unstable mounting.

aMount the unit securely with the mounting parts, referring to the section on Installation.

¡Disc is defective. ¡Mechanical trouble.

aOpen the panel and press [u]. If normal operation is not restored, call the store where you purchased the unit or the nearest Panasonic Service Center to ask for repairs.

Time is counted but no

The 1st track of a mix mode disc was reproduced. (Mix mode is a format in

which data except music is recorded on the 1st track and music data is

sound comes out.

recorded on other than the 1st track in a session.)

 

aPlayback music data recorded on other than the 1st track.

38CQ-DFX602N

Page 38
Image 38
Panasonic manual 38CQ-DFX602N, APlace disc in the correct direction with the label side up