E
N
G
L
I
S
H
37
Electrical Connections
Cautions:
¡This product is designed to operate off a 12 volt, negative ground battery system. ¡To prevent damage to the unit, be sure to follow the connection diagram bellow.
¡Remove approx. 1/4” (5 mm) of protective covering from the ends of the leads before connecting. ¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires from a possible
¡Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when the battery terminals are disconnected.
Supplied hardware |
| SD/CD Receiver | ||||
|
|
| ||||
No. | Item | Q’ty |
| |||
|
|
| (Rear) | |||
e | Power Connector | 1 | ||||
|
|
| ||||
|
|
| Antenna |
|
| |
❏ Wiring Diagram |
|
|
| |||
|
| |||||
|
|
|
| |||
|
|
|
| |||
|
|
|
|
Navi Mute Lead |
|
|
|
|
Connect to the Navi Mute Lead of the Panasonic |
|
| NAVI MUTE |
|
|
| (Orange) | ||
car navigation system (not available yet). |
|
|
|
Note: Insulate the Navi Mute Lead with vinyl tape when you do not connect it.
CD Changer
Control
Connector
ePower Connector
Antenna Control Cord
To the auto antenna control power cord of the car
Illumination Lead
To the power line connected to the side marker lights of the car
Dual CD Changer Control Lead (not used) Note: Insulate the Dual CD Changer Control Lead with vinyl tape.
External Amplifier Control Power Lead
To an external amplifier
ACC Power Lead
To ACC power, +12V DC
Battery Lead
To the car battery, continuous +12V DC
Ground Lead
To a clean, bare metallic part of the car chassis
(Blue)
ILLUMINATION (Orange / white stripe)
TWIN
(Brown / white stripe)
(Blue / white stripe)
ACC
(Red) | Resistor (1kΩ) |
BATTERY 10A
(Yellow) Fuse (10A)
(Black)
Note: If your car does not have a power line connected to the side marker lights of the car, leave the illumination lead disconnected.
46