English
5
Installation (continued)
Mounting the Main Unit
❏ Installation Procedures (When using Mounting Collar w)
Note:
¡The car model, installation condi- tions and combination of the units used may impose some restric- tions on opening and closing the monitor as well as on the angle and position to which the monitor can be adjusted.
IMPORTANT
When this unit is installed in dash- board, ensure that there is sufficient air flow around the unit to prevent damage from overheating. Do not block any ventilation holes on the unit.
r Mounting Bolt (5 mmø)
1
!3Power Connector
eMounting Spring
Insert the Mounting Collar w into the dashboard, and bend the mounting tabs out with a screwdriver.
Fastening the Mounting Collar
How much to bend the tabs will vary depending on the car. Bend them with a screwdriver to fasten the Mounting Collar w securely in the dashboard.
Dashboard
w Mounting Collar
Tab
2
o
(5 mmø x 6 mm) 3
4
5
6
Attach the Mounting Springs e to the unit.
Establish the rear connection of the unit.
After fixing Power Connector !3, fix the rear of the unit to the car body by either method (a) or (b) shown at right.
Insert the unit into Mounting Collar w. Secure the clamp plate of Mounting Collar w to the hook of Mounting Spring e.
Clamp plate
Insert Trim Plate q.
After installation reconnect the negative
(–) battery terminal.
6
