Panasonic CU-3KE19NBU, CS-MKE9NKU, CS-MKE7NKU, CU-4KE31NBU, CU-4KE24NBU Remote Controller Continued

REMOTE CONTROLLER (CONTINUED)

MODE selector button		Use this button to select AUTO, HEAT, DRY or COOL mode.
	(AUTO)		: The air conditioner calculates the difference between the thermostat
			setting and room temperature, and automatically selects ‘‘COOL’’ or
			‘‘HEAT’’ mode as appropriate.
	(HEAT)		: The air conditioner makes the room warmer.
	(DRY)		: The air conditioner reduces the humidity in the room.
(COOL)			: The air conditioner makes the room cooler.
		When multiple indoor units are used and units in other rooms are already operating, they
	NOTE
		will be set to the same mode of operation as the operating indoor units.
FAN SPEED selector button			: The air conditioner automatically decides the fan speeds.
			: High fan speed
			: Medium fan speed
			: Low fan speed
NIGHT SETBACK button		For details, see “4. Night Setback Mode”. When you press this button in the
		HEAT, DRY or COOL mode, the mark appears in the display, and the remote
		controller will automatically adjust the set temperature to save energy.
FLAP button		Press this button either to select the setting of the airflow direction to the auto.
		flap in each mode or one of the six possible positions manually or to select the
		sweep function which moves the flap up and down automatically.
			: Auto flap setting: If selected in a heating operation, the flap is set to
			position (3) in the following chart. If selected in a cooling or dry operation,
			the flap is set at position (7) in the following chart.
			: The airflow direction can be set manually. (six positions)
			: The flap moves up and down automatically.
		When you press the FLAP button, the air flow direction will be changed one by
	NOTE
		one as follows.
					SWEEP
HIGH POWER button			: If this button is pressed during HEAT, DRY or COOL operation, the unit
			operates at maximum output for 30 minutes, regardless of the desired
			temperature.
			The fan speed is 1 step above “High”.
ON TIME/OFF TIME setting		No display: The timer does not operate.
buttons			: The air conditioner starts at the set time.
			: The air conditioner stops at the set time.
				: The air conditioner stops and starts, or starts and stops, at the
				set times every day. For details, see “SETTING THE TIMER”.
SENSOR button		When you press this button (use a small-tipped object such as a ballpoint pen),
		the	mark will appear at the display. And the room temperature is detected by
		the sensor which is built into the indoor unit and the air conditioner is controlled
		accordingly.
		If the remote controller is located near a heat source, such as a space heater or in
	NOTE
		direct sunlight, press the SENSOR button to switch to the sensor on the indoor unit.

NOTE

The indoor fan runs continuously when the system is in normal operation. It does not turn off when the desired room temperature is reached. If Night Set Back mode is selected, the fan will turn off intermittently during cooling operation in order to control air flow.

9