75 Ohm VHF/UHF
on back of TV
Incoming Cable from
Cable Company

ENGLISH

INSTALLATION

Installation

Television Location

This unit is intended to be used with an optional stand or entertainment center. Consult your dealer for available options.

Avoid excessive sunlight or bright lights, including reflections.

Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.

Fluorescent lighting may reduce remote control transmitting range.

Keep away from magnetic equipment, including motors, fans and external speakers.

WARNING: Use this television receiver only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. In order to

avoid injury to children, never place your television receiver on a piece of furniture that is capable of being tilted by a child leaning on it, pulling on it, standing on it, or climbing on it. A falling television can cause serious injury or even death.

CT-32HC15, CT-32HC15U:

CAUTION: These television receivers for use only with PANASONIC TY-32SC15T stand. Use with other carts (or stands) is capable of resulting in instability causing possible injury.

CT-32HL15, CT-32HL15U:

CAUTION: These television receivers for use only with PANASONIC TY-32HL15T stand. Use with other carts (or stands) is capable of resulting in instability causing possible injury.

Optional Cable Connections

Shielded audio and video cables should be used between components. For best results:

Use 75-ohm coaxial shielded cables.

Use appropriate input and output connectors, that match your component connectors.

Avoid long cables to minimize interference.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK,

MATCH WIDE BLADE OF PLUG TO WIDE SLOT

OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug

USE A PLUG WITH A RECEPTACLE OR OTHER

OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS.

Cable / Antenna Connection

For proper reception, either a cable or antenna connection is required.

Cable Connection

Connect the cable supplied by your local cable company. Tighten with fingers only. Use of any tool (e.g. pliers) for tightening may result in tuner damage.

Note: A cable converter box may be required for proper reception. Check with your local cable company for compatibility requirements.

Antenna Connection

For proper reception of VHF/UHF channels, an

 

external antenna is required. For best reception an

 

outdoor antenna is recommended.

Connect home antenna to

Incoming Cable from

 

ANT connection on back of

Home Antenna

 

television. Select TV mode in

 

 

the SET UP menu.

 

Note: Cable Mode is preset at the factory. Antenna users must change to TV Mode in the Set Up menu (page 15).

Remote Control Battery Installation

Requires two AA batteries (supplied).

Battery Polarity

5A.

 

1 /

AA

 

AA / 1.

 

5A

 

1

2

3

Procedure

1.Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated.

2.Install batteries matching (+) and (-) polarity signs.

3.Replace the battery cover by sliding in reverse until the lock snaps.

Note: Incorrect installation can cause battery leakage and

corrosion that will damage the Remote Control.

Precautions

Replace batteries in pairs.

Do not mix battery types (zinc carbon with alkaline).

Do not recharge, heat, short-circuit, disassemble, or burn batteries.

4z

Page 6
Image 6
Panasonic CT-32HC15 manual Installation