English | Safety Information (continued) |
|
English
3
Caution
Observe the following cautions when using this unit.
This unit is designed for use exclusively in automobiles.
Do not operate the unit for a prolonged period with the engine turned off.
Operating the audio system for a long period of time with the engine turned off will drain the battery.
Do not expose the unit to direct sunlight or excessive heat.
Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit.
Do not use the product where it will be exposed to water, moisture, or dust.
Exposure of the unit to water, moisture, or dust may lead to smoke, fire, or other damage to the unit. Make especially sure that the unit does not get wet in car washes or on rainy days.
Observe the following cautions when installing.
If your car is equipped with air bag and/or
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVATION OF THE
Refer wiring and installation to qualified service personnel.
Installation of this unit requires special skills and experience. For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit.
Follow the instructions to install and wire the product. Not following the instructions to properly install and wire the product could cause an accident or fire.
Take care not to damage the leads.
When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.
Use the designated parts and tools for installation. Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those supplied or designated may result in internal damage to the unit. Faulty installation may lead to an accident, a malfunction or fire.
Do not install the product where it is exposed to strong vibrations or is unstable.
Avoid slanted or strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.
Ware gloves for safety. Make sure that wiring is completed before installation.
To prevent damage to the unit, do not connect the power connector until the whole wiring is completed.
Never mount the unit in any of the following locations to avoid damage due to overheating;
•Near the heater port.
•Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
Do not mount the unit near the door, where it could be exposed to rain.
You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring harness, or other component.
Note that if your car has a driving computer or a navigation computer, disconnecting the cable from the battery may clear the memory.
Fit a vinyl cap over unused connection terminals, to prevent contact with metal parts etc.
Caution
Observe the following cautions when mounting the TV antennas.
Attach the TV antenna so that it does not protrude. If the antenna element extends beyond the front and rear of the vehicle or car, it could hit eyes or heads of pedestrians and potentially cause an accident or an injury.
Place the TV antenna so that it does not impede driving or visibility. If the antenna is in a position that impairs forward or backward visibility, it could interfere with driving and cause an accident.
Do not disassemble or modify the TV antenna. Such modification could start smoke or fire.
Fasten the TV antenna securely, so that it cannot drop off. If the screws are loose or the bond at the mounting is weak, the antenna could fall off, potentially causing damage to the car bodywork, accident or injury. Inspect it occasionally.
Be sure to install the TV antenna on the inner side of the rear window.
Be sure to connect the power lead of the TV antenna to ACC power DC 12 V.
Keep the antenna away from the external amplifier and the rear speaker cord as much as possible.
Be sure to connect the grounding plate into the TV antenna body. Otherwise, desensitization will occur.
Avoid contacting the back of the TV antenna body on the adhesive surface.
Do not
Avoid adhering the TV antenna on the heating wire as much as possible.
Caution
Observe the following cautions when handling the batteries for the remote control unit.
Proper Use of the Batteries
Use only specified battery (CR2025).
Match the polarity of the battery with the () and () marks in the battery case.
Replace a dead battery as soon as possible.
Remove the battery from the remote control unit when not using it for an extended period of time.
Insulate the battery (by placing them in a plastic bag or covering them with vinyl tape) before disposal or storage.
Do not disassemble, recharge, heat or short the battery. Do not throw a battery into a fire or water.
Follow local regulations when disposing of a battery.
Improper use of a battery may cause overheating, an explosion or ignition, resulting in injury or a fire.
In case of battery leakage
Thoroughly wipe the battery liquid off the battery case and insert new battery.
If any part of your body or clothing comes into contact with battery liquid, wash it with plenty of water.
If battery liquid comes into contact with your eyes, wash them with plenty of water and get immediate medical attention.
4
4 |
|
| 5 | ||
|
|
|
|
|
|
