Panasonic DMC-FS25 Open the DC coupler cover a, Ensure that the card/battery door is closed

Preparation

1: Close the card/battery door.

2: Slide the release lever in the direction of the arrow.

• If the card/battery door cannot be completely closed, remove the card, check its direction and then insert it again.

Note

•Remove the battery after use. Store the removed battery in the battery case (supplied).

•Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the settings on the camera may not be stored properly.

•The supplied battery is designed only for the camera. Do not use it with any other equipment.

•Before removing the card or battery, turn the camera off, and wait until the status indicator has gone off completely. (Otherwise, this unit may no longer operate normally and the card itself may be damaged or the recorded pictures may be lost.)

∫Using an AC adaptor (optional) and a DC coupler (optional) instead of the battery

Ensure that the AC adaptor (DMW-AC5PP; optional) and DC coupler (DMW-DCC4; optional) are purchased as a set. Do not use if sold separately.

1Open the card/battery door.

2Insert the DC coupler, being careful of the

direction.

3Close the card/battery door.

•Ensure that the card/battery door is closed.

4 Open the DC coupler cover A.

•If it is difficult to open, push open the coupler cover from the interior with the card/battery door in an open state.

5Plug the AC adaptor into an electrical outlet.

6Connect the AC adaptor B to the [DC IN] socket C of the DC coupler.

DAlign the marks, and insert.

•Ensure that only the AC adaptor and DC coupler for this camera are used. Using any other equipment may cause damage.





Note

•Always use a genuine Panasonic AC adaptor (DMW-AC5PP; optional).

•Some tripods cannot be attached when the DC coupler is connected.

•This unit cannot stand upright when the AC adaptor is connected. When operating it on a flat surface, we recommend placing it on a soft cloth.

•Make sure to unplug the AC adaptor when you open the card/battery door.

•If the AC adaptor and DC coupler are not necessary, then remove them from the digital camera. Also, please keep the DC coupler cover closed.

•Also read the operating instructions for the AC adaptor and DC coupler.

•For information about optional accessories, refer to the “Digital Camera Accessory System”. (P110)

VQT1W65 15