Panasonic DMC-FX3 Taking Pictures using the Built-in Flash, Press 2 Press 3/4 to select a mode

Advanced

∫Canceling High angle mode or Power

LCD

•If you press and hold [LCD MODE] again for 1 second the screen shown in step 2

is displayed. Select [OFF] to cancel Power LCD mode or High angle mode.

•High angle mode is also canceled if you turn the camera off or power save mode is activated.

•The brightness of the pictures displayed on the LCD monitor is adjusted when Power LCD mode or High angle mode is activated. Therefore, some subjects may look different on the LCD monitor. However, this does not affect the recorded pictures.

•The LCD monitor automatically returns to normal brightness after 30 seconds when recording in Power LCD mode. Press any button to make the LCD monitor bright again.

•You may not notice the High angle mode effect if the LCD monitor is difficult to see because of light from the sun etc. shining on it. In this case, we recommend using your hand or another object to block the light when using the camera.

•High angle mode is not activated in the following cases.

–In simple mode [ ]

–In playback mode

–While the menu screen is displayed

–While the review screen is displayed

Taking Pictures using the Built-in Flash

A: Photo flash

Do not cover it with your fingers or other objects.

∫Switching to the appropriate flash

setting

Set the flash to match the recording.

1Press 1 [ ].

2Press 3/4 to select a mode.

FLASH

	AUTO
	AUTO/RED-EYE
	FORCED FLASH ON
	SLOW SYNC./RED-EYE
	FORCED OFF
SELECT	SET MENU

•You can also press 1 [ ] to select.

•For information about flash settings that can be selected, refer to “Available flash settings by recording mode”. (P40)

3 Press [MENU/SET].

•You can also press the shutter button halfway to finish.

•The menu screen disappears after about 5 seconds. At this time, the selected item is automatically set.

39

VQT0Y69