Making the LCD monitor easier to see (LCD mode)
1�Press and hold [Q.MENU] until quick setting screen is displayed.
Q.MENU
2�Select indication at the right end (initial setting: [OFF]) using Q, select mode using E/R and press [MENU/SET].
SELECT
EXIT
ModeUses
Brightness of the LCD monitor
AUTO automatically changes
POWER LCD depending on brightness of the environment.
| The LCD monitor becomes |
POWER | brighter and easier to see |
LCD | even when taking pictures |
| outdoors. |
| This is useful |
HIGH | when you cannot |
ANGLE | get close to the |
| subject because |
| there is a person |
| in the way. |
| (More difficult to |
| see when looked |
| straight on.) |
OFF | The LCD monitor returns to |
| the normal brightness. |
•You can set LCD mode in setup menu. (P21)
•High angle mode is cancelled if you turn the camera off. (Same occurs in [POWER SAVE].)
•The LCD monitor automatically returns to normal brightness after 30 seconds when recording in power LCD mode. Press any button to make the LCD monitor bright again.
•The brightness of the pictures displayed on the LCD monitor is adjusted when power LCD mode or high angle mode is activated. Therefore, some subjects may look different on the LCD monitor. However, this does not affect the recorded pictures.
•If the screen is difficult to see because of light from the sun etc. shining on it, use your hand or another object to block the light.
•The number of recordable pictures decreases when the auto power LCD, power LCD or high angle mode is used.
- 38 -