15
•4. How to read the error code:One error code is displayed for 8 bit, the contents of error codes is indicated the table as shown below.
Attribute Main item Sub item Error code Contents (Upper)
High 4 bits Low 4 bits Check point (Lower)
LENS Lens drive OIS 1800 1000 PSD (X) error. Hall element (X axis) position detect error in OIS unit.
OIS Unit
2000 PSD (Y) error. Hall element (Y axis) position detect error in OIS unit.
OIS Unit
3000 GYRO (X) error. Gyro (IC7101: X axis) detect error on Main P.C.B..
IC7101 (Gyro element) or IC6001 (VENUS 3)
4000 GYRO (Y) error. Gyro (IC7101: Y axis) detect error on Main P.C.B..
IC7101 (Gyro element) or IC6001 (VENUS 3)
5000 MREF error (Reference voltage error).
IC7001 (LENS drive) or IC6001 (VENUS 3)
6000 Drive voltage (X) error.
OIS Unit, LENS flex breaks etc.
7000 Drive voltage (Y) error.
OIS Unit, LENS flex breaks etc.
C.B./Zoom 0100 HP Low detect error (C.B. encoder (full retract) always Low detect).
FP9004-(6, 7) signal line or IC6001 (VENUS 3)
0200 HP High detect error (C.B. encoder (full retract) always High detect).
FP9004-(6, 7) signal line or IC6001 (VENUS 3)
0300 ENC1 detect error (C.B. motor encoder detect error).
Zoom motor, Motor driver, Zoom pulse encoder 1.
0400 ENC2 detect error (C.B. motor encoder detect error).
Zoom motor, Motor driver, Zoom pulse encoder 2.
Zoom 0010 HP Low detect error (Zoom encoder always Low detect error).
0020 HP High detect error (Zoom encoder always High detect error).
Focus 0001 HP Low detect error (Focus encoder always Low detect error).
FP9004-(6, 7) signal line or IC6001 (VENUS 3)
0002 HP High detect error (Focus encoder always High detect error).
FP9004-(6, 7) signal line or IC6001 (VENUS 3)
0005 Focus lock error (Focus is not possible to drive to a specified position).
Obstacle mixing, Focus MR sensor output, Motor driver.
0006 Focus comparate sinal (phase A) is irregular.
Focus Motor, Focus MR sensor output, Motor driver.
0007 Focus comparate sinal (phase B) is irregular.
Focus Motor, Focus MR sensor output, Motor driver.
0008 Focus reference voltage is irregular.
Motor driver.
Lens 1801 0000 Power ON time out error.
Lens drive system
1802 0000 Power OFF time out error.
Lens drive system