
Changing the remote control code
DVD POWER TV
DVD TV
ÍÍ
VCR Plus+ TV/VIDEO REC MODE REC
Numbered | 1 | 2 | 3 | |
buttons |
|
| CH | |
| 4 | 5 | 6 | |
|
|
| VOLUME | |
| 7 | 8 | 9 | |
| CANCEL |
| ||
|
| 0 | 100 | |
|
|
| SLOW/SEARCH | |
| HDD | DVD |
| |
| DIRECT NAVIGATOR | PLAY LIST | ||
| TOP |
| MENU | |
| MENU |
|
| |
3, 4, 2, 1 |
| ENTER | ||
ENTER |
|
|
| |
| FUNCTIONS |
| RETURN | |
| PROG/CHECK | ADD/DLT | DISPLAY TIME SLIP | |
| OPEN/CLOSE STATUS | SKIP | ||
SET UP | SET UP | AUDIO | INPUT SELECT CM SKIP | |
ERASE | DUBBING | POSITION MEMORY MARKER | ||
|
3, 4, 2, 1
ENTER
FUNCTIONS RETURN
Most of the DVD recorders and players manufactured by Panasonic use the same remote control system. If you have more than one piece of equipment placed in proximity to each other, they may all respond to the signal. If this occurs, you will have to alter the code on the unit as well as on the remote control (the two must match) using the following procedure.
≥Use “1”, the factory set code, under normal circumstances.
!?
1 Press [SET UP] to show the menus.
SET UP | Antenna System | CATV |
| ||
| Auto Channel Setting |
|
Channel | Channel Caption |
|
Preset Channel Caption |
| |
Set Up |
| |
Manual Channel Caption |
| |
Disc |
| |
|
| |
Video | VCR PlusiCH Setting |
|
Audio |
|
|
Display | TAB SELECT |
|
TV Screen | RETURN |
|
2 Press [3, 4] to select “Set Up” and press [1].
3 Press [3, 4] to select “Remote Control Code” and press [ENTER].
4 Press [3, 4] to select the code (1, 2, or 3) and press [ENTER].
The remote control code on the unit has been set.
5 While pressing [ENTER] on the remote control, press the numbered button ([1], [2] or [3]) corresponding to the code you selected in step 4.
The remote control code on the remote control has been set.
6 Press [SET UP]
If the unit doesn’t respond, you have entered the wrong code. Repeat step 5 to enter the correct code.
[Note]
The following display appears on the unit’s display if its code and the remote control’s code are different. Change the remote control’s code to suit the unit. The display disappears after about 5 seconds.
The unit’s remote control code
≥You can also set the unit’s code without using the remote control. 1 Press [FUNCTIONS] on the unit.
2 Press [3, 4, 2, 1] to select “SET UP” and press [ENTER]. 3 Carry out procedure
4 Press [RETURN].
Advanced operation
65
RQT6570