Playback (sound)

Cannot hear any sound

• You may have turned down the camera-recorder’s volume control

P 49

from the camera-

too far.

 

recorder’s speaker.

In the VCR mode, adjust the volume level using the AUDIO MON/

 

 

VAR button+.

 

I can hear two sets of

• You may have selected “MIX” as the 32K (12bit) AUDIO setting in

P 73

sound.

the PLAYBACK FUNCTION screen.

 

 

• If you perform audio dubbing on a tape that was recorded with

P 74

 

32K (12bit) selected as the AUDIO REC setting in the

 

 

RECORDING SETUP screen, you will hear the sound heard

 

 

during recording and that of the audio dubbing. You can also

 

 

listen to each sound separately.

 

 

 

 

When I performed

• If you perform audio dubbing on a tape that was recorded with

P 74

audio dubbing, the

32K (12bit) selected as the AUDIO REC setting in the

 

original sound was

RECORDING SETUP screen, you will hear the sound heard

 

erased.

during recording and that of the audio dubbing. To leave the

 

 

original sound intact, make sure that 32K (12bit) is selected when

 

 

you shoot.

 

 

 

 

Other

Cannot remove the

• Make sure the camera is supplied with power.

P 10

 

 

cassette tape.

Make sure the AC adapter or battery is inserted correctly.

 

 

 

 

As long as the power is supplied, you can remove the cassette

 

 

 

 

without turning ON the POWER switch.

 

 

 

 

 

 

 

 

Cannot perform any

• Condensation may have formed.

P 82

 

 

operation other than

If this happens, the only operation that you will be able to perform

 

 

 

removing the cassette.

is to remove the cassette. Wait until the condensation has dried

 

 

 

 

out.

 

 

 

 

• When the cassette holder is closed immediately after sliding

—

 

 

 

EJECT switch to open the cassette holder, sometimes operations

 

 

 

 

other than eject cannot be performed. In this case, slide EJECT

 

 

 

 

switch again to open the cassette holder, check that the cassette

 

 

 

 

mechanism has completed ejecting operation, and then close the

 

 

 

 

cassette holder.

 

 

 

The remote control

• The button battery in the remote control may have run out.

P 20

 

 

does not work.

If the remote control fails to work even if it is operated close to the

 

 

 

 

remote control sensor of the camera-recorder, it means that the

 

 

 

 

button battery has run out. Replace it with new one.

 

 

 

 

• Make sure the remote control setting is the same for the remote

P 20,

 

 

 

control unit and the camera-recorder.

P 77

 

 

 

If the REMOTE setting is different on the remote control and the

 

 

 

 

camera-recorder, the remote control will not work.

 

 

 

 

 

 

 

 

There is a rattling

• There are some parts of the camera that make a rattling sound in

—

 

Reference

sound when the

the VCR mode or when the POWER switch is OFF. This is

 

 

camera-recorder is

normal.

 

 

 

 

 

tilted back and forth.

 

 

 

 

 

 

 

 

 

81