Panasonic EP1060 manual Troubleshooting, Problem, Cause and Remedy, Motor Noises, or Vibration

Models: EP1060

1 56
Download 56 pages 52.97 Kb
Page 26
Image 26
TROUBLESHOOTING

TROUBLESHOOTING

Before requesting service for this unit, check the table below for the possible cause of the problem. Some simple checks or minor adjustment on your part may eliminate the problem and restore proper operation. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, call us at 1-800-338-0552 to locate the servicer near to you.

Problem

Cause and Remedy

Motor Noises

• The motor gets louder when it comes under load.

 

 

• There is excessive noise during Tapping.

 

 

(The noise is louder at the top of the unit.)

H

These sounds are perfectly normal and will not have

• The motor sounds louder when adjusting massage

intensity and width.

 

any effect on the operation of the unit.

• There is a rubbing sound produced by the massage

 

 

heads rubbing on the seat fabric.

 

 

• There is a rubbing sound produced by fabric rubbing

 

 

on fabric.

 

 

 

 

 

The massage heads stop during operation.

H

When the massage heads are raised or lowered, if

they come into contact with a wall or other obstruction,

 

 

in the interests of safety the massage heads may

 

 

stop moving. In such a situation, move the chair or

 

 

remove the obstruction and start the massage again.

 

 

If all markings and buttons on the controller start to

 

 

flash, which is extremely unusual, turn off the power

 

 

switch, wait for approximately 10 seconds and then

 

 

turn the power switch on again.

 

H

If excessive force is applied to the massage heads

 

during operation, in the interests of safety the

 

 

massage heads may stop moving. If this occurs,

 

 

raise your body slightly before restarting it.

 

 

If all markings and buttons on the controller start to

 

 

flash, which is extremely unusual, turn off the power

 

 

switch, wait for approximately 10 seconds and then

 

 

turn the power switch on again.

 

 

 

Nothing can be felt when using Tap A, Tap B

H

If the massage heads are not touching your body

or Vibration.

 

then you will, of course, feel nothing. Therefore,

 

 

please make sure that your body comes into close

 

 

contact with the massage heads.

 

 

 

The massage heads do not come up to the

H

The position of the shoulders is incorrect.

shoulder or neck.

 

(See Page 14)

26

Page 26
Image 26
Panasonic EP1060 manual Troubleshooting, Problem, Cause and Remedy, Motor Noises, The massage heads stop during operation