TROUBLESHOOTING
Problem
Cause and Remedy
Does not start even after pressing the OFF/ON button.
The unit will not operate at all.
•The power plug is not securely inserted into the outlet.
In this case, securely insert the power plug into the outlet. (See page 7)
•The lock switch key is in the “lock” position. In this case, set it to the “open” position. (See page 7)
•The main power switch is off. In this case, turn the main power switch on. (See page 7)
•After pressing OFF/ON button
The unit stopped operation and all | • An extremely heavy load was applied. | Reset the flashing |
the lamps on the control panel flashed. | lights by pressing the OFF/ON button. | (See page 10) |
Operation of the unit moves fast then slow.
•Your bodyweight shifted to one side of the unit. Refer to the basic posture and sit properly. (See page 9)
The tilting of the seat (left and right) is not even.
•Your bodyweight shifted to one side of the unit or you were not sitting in the center of the seat. Refer to the basic posture and sit properly. (See page 9)
Note: If the problem is not solved by the above remedies, immediately stop using the unit.
Seat reclines during stop. | • This occurs since the seat is designed to move in a figure |
| eight pattern and is not an indication of a problem. |
Noise is heard during operation.
•This occurs due to the design and is not an indication of a problem.
Unusual or periodic noise is heard during operation.
• Immediately stop using the unit.
16
