b. extension cord is properly wired and in good electrical condition.

c. wire size is large enough for ampere rating of charger as specified below.

RECOMMENDED MINIMUM AWG SIZE OF

EXTENSION CORDS FOR

BATTERY CHARGERS

AC Input Rating.

Amperes

AWG Size of Cord

Equal to or

But less

Length of Cord,

 

greater than

than

Feet

 

 

 

 

 

25

50

100 150

0

2

18

18

18

16

8)Do not operate charger with damaged cord or plug-replace them immediately.

9)Do not operate charger if it has received a sharp blow, been dropped, or other­ wise damaged in any way; take it to a qualified service personnel.

10)Do not disassemble charger; take it to a qualified service personnel when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

11)To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning.

12)The charger and battery pack are specifically designed to work together. Do not attempt to charge any other cordless tool or battery pack with this charger.

13)Do not attempt to charge the battery pack with any other charger.

14)Do not attempt to disassemble the battery pack housing.

15)Do not store the tool and battery pack in locations where the temperature may reach or exceed 50°C (122°F) (such as a metal tool shed, or a car in the summer), which can lead to deterioration of the storage battery.

16)Do not charge battery pack when the temperature is BELOW 0°C (32°F) or ABOVE 40°C (104°F). This is very important in order to maintain optimal condition of the battery pack.

17)Do not incinerate the battery pack. It can explode in a fire.

18)Avoid dangerous environment. Do not use charger in damp or wet locations.

19)The charger is designed to operate on standard household electrical power only. Do not attempt to use it on any other voltage!

20)Do not abuse cord. Never carry charger by cord or yank it to disconnect from outlet. Keep cord away from heat, oil and sharp edges.

21)Charge the battery pack in a well ventilated place, do not cover the charger and battery pack with a cloth, etc., while charging.

22)Use of an attachment not recommended may result in a risk of fire, electric shock, or personal injury.

23)Do not short the battery pack. A battery short can cause a large current flow, over heating and create the risk of fire or personal injury.

24)NOTE: If the supply cord of this appliance is damaged, it must only be replaced by a repair shop authorized by the manufacturer, because special purpose tools are required.

25)TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER).

This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

WARNING:

Do not use other than the Panasonic bat- tery packs that are designed for use with this rechargeable tool.

Panasonic is not responsible for any dam- age or accident caused by the use of the recycled battery pack and the counterfeit battery pack.

Do not dispose of the battery pack in a fire, or expose it to excessive heat.

Do not drive the likes of nails into the battery pack, subject it to shocks, dismantle it, or attempt to modify it.

Do not allow metal objects to touch the battery pack terminals.

Do not carry or store the battery pack in the same container as nails or similar metal objects.

Do not charge the battery pack in a high-temperature location, such as next to a fire or in direct sunlight. Otherwise, the battery may overheat, catch fire, or explode.

Page 6
Image 6
Panasonic EY7546 operating instructions Amperes AWG Size of Cord Equal to or But less