•Never use other than the dedicated char- ger to charge the battery pack. Otherwise, the battery may leak, overheat, or explode.
•After removing the battery pack from the tool or the charger, always reattach the pack cover. Otherwise, the battery con- tacts could be shorted, leading to a risk of fire.
•When the Battery Pack Has Deteriorated, Replace It with a New One.
Continued use of a damaged battery pack may result in heat generation, ignition or battery rupture.
IV. ASSEMBLY
Attaching or Removing Bit
NOTE:
•When attaching or removing a bit, discon- nect battery pack from tool or place the switch in the center position (switch lock).
1.Hold the collar of quick connect chuck and pull it out from the driver.
2.Insert the bit into the chuck. Release the collar.
3.The collar will return to its original position when it is released.
4.Pull the bit to make sure it does not come out.
5.To remove the bit, pull out the collar in the same way.
CAUTION:
•If the collar does not return to its origi- nal position or the bit comes out when pulled on, the bit has not been properly attached. Make sure the bit is properly attached before use.
Use 6.35 mm (1/4") hexagonal bits.
To ensure proper securement of the bit, use only hexagonal bits with 9.5 mm (3/8") detent.
6.35 mm (1/4") | 9.5 mm (3/8") | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Attaching or Removing Socket
1.Attaching Socket
Attach the socket by sliding the female detent on the bottom of the socket to the square drive on the body.
Make sure the socket is firmly connected to the body.
2.Removing Socket Pull out the socket.
NOTE:
Attaching or Removing Original Options and Sockets
Keep the body above freezing point (0°C 32°F) when attach or detach original options and sockets to the square drive on the body. The cushion rubber in the square drive to push up the ball may get hard under freezing point. This requires extra force in detaching and attaching sockets.
Attaching or Removing Battery Pack
1.To connect the battery pack:
Line up the alignment marks and attach the battery pack.
•Slide the battery pack until it locks into position.
Alignment 
marks 
2.To remove the battery pack:
Pull the button from the front to release the battery pack.
Button 
