Control Panel (4) (3)
(1)
(2)
(1) Impact Power Mode Select
Selecting the impact power among 3 modes (Soft, Medium, Hard).
Press the impact power mode button to set it. The mode changes to hard, medium, or soft each time the button is pressed.
The driver is preset to “hard” impact mode setting when shipped from the manufac- turer.
Recommended work guideline table
Impact | Recommended Application | |
Power mode | ||
Display |
| |
H | Jobs requiring a high level | |
of torque where there is | ||
no possibility of the screw | ||
| breaking, its top shearing off, | |
0 – 2300 r.p.m./ | or the bit coming loose. (This | |
0 – 2500 r.p.m. | setting provides maximum | |
torque.) Suitable applications | ||
and | ||
include: | ||
0 – 3000 i.p.m./ | ||
Tightening M8 and larger | ||
0 – 3300 i.p.m./ | ||
bolts | ||
0 – 3500 i.p.m. | Tightening long screws | |
| during interior finishing work | |
M | Jobs requiring limited torque | |
where there is a possibility of | ||
the screw breaking or its top | ||
| shearing off. (This setting limits | |
| torque.) Suitable applications | |
0 – 1400 r.p.m. | include: | |
and | Tightening bolts with | |
smaller diameters (M6) | ||
0 – 2800 i.p.m. | ||
Tightening metalwork | ||
| screws when installing | |
| fixtures | |
S | Jobs requiring limited torque | |
where there is a possibility | ||
of the screw breaking, its | ||
| top shearing off, or the bit | |
| coming loose and damaging | |
| a finished exterior surface. | |
0 – 1000 r.p.m. | (This setting limits torque.) | |
Suitable applications include: | ||
and | Tightening bolts smaller | |
0 – 2000 i.p.m. | than M6 that may shear | |
| easily | |
| Tightening screws into | |
| molded plastic | |
| Installing gypsum wallboard |
* i.p.m. = Impact per minute.
Avoid repeatedly depressing the switch when the bolts and screws are securely fastened.
Not doing so may cause a delay in rotation starting, or the Impact Power mode display to flash and prevent rotation from starting for circuit protection.
(2) LED light
Pressing the 
button toggles the LED light on and off.
The light illuminates with very low current, and it does not adversely affect the performance of the driver during use or its battery capacity.
CAUTION:
•The
•Do not use it as a substitute for a regu- lar flashlight, since it does not have enough brightness.
This product has the
Class 1 LED Product
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
(3) Overheat warning lamp
Off (normal | Flashing: Overheat |
operation) | Indicates operation has |
| been halted due to motor |
| or battery overheating. |
The overheating protection feature halts driver operation to protect the motor and battery pack in the event of overheating. The overheat warning lamp on the control panel flashes when this feature is active.
•If the overheating protection feature acti- vates, allow the driver to cool thoroughly (at least 30 minutes). The driver is ready for use when the overheat warning lamp goes out.
•Avoid using the driver in a way that causes the overheating protection fea- ture to activate repeatedly.
