43
VQT3K35
The unit is put into recording pause approx. 1second when the unit is turned on with the
mode set to or .
≥Depending on the recording conditions, start time may be longer than 1second.
≥In the Quick power on mode, the zoom magnification becomes 1k.
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopene d.
≥When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥Quick start will not work if there is no SD card inserted.
≥Change the mode to or .
1Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is set to
or .
The status indicator A flashes green and the unit goes into
Quick start standby mode.
≥The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into
recording pause.
≥Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
≥Depending on the recording conditions and menu settings, ti m e for Quick start may be
longer than 0.6 seconds.
≥It may take some time for Automatic white ba lance to adjust.
≥In the Quick Start Mode, the zoom magnification becomes 1k.
≥If [ECONOMY] (l42) is set to [5 MINUTES] an d the u ni t a ut oma tic ally goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
≥Turn the unit off using the power button.
≥Quick start standby mode cannot be released by the remote control.
Please refer to page 47.
[QUICK POWER ON] [OFF]/[ON]
[QUICK START] [OFF]/[ON]
[REMOTE CONTROL] [OFF]/[ON]
HDCSD800P-VQT3K35_mst.book 43 ページ 2010年12月20日 月曜日 午前9時4分