Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby’s room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
RYou should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
Note:
RBoth the monitored and monitoring
handsets must select the same base unit in
order to use the baby monitor feature
(page 32).
RIf the unit is connected to a PBX system,
you cannot set the baby monitor.
RDuring the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
RThe monitored handset never rings during
the monitoring mode.

Setting the baby monitor

Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).

To monitor with a handset

The internal baby monitor feature is only
available between handsets in the same radio
cell.
1MMenuN (right soft key) #268
2MbN: “On” a MOKN
3MbN: Select the desired handset number
to monitor with. a MOKN
R“Baby Monitor” will be displayed.
RThe registered handset name/number
is displayed.
Note:
RWhen this feature is on, another handset
can hear the monitored handset by making
an intercom call.

To monitor from an outside line

nFrom the phonebook:
1MMenuN (right soft key) #268
2MbN: “On” a MOKN
3MbN: Select “External” to monitor
from an outside line. a MEditN a
MAddN
4MbN: “Phonebook” a MOKN
5MbN: Select the phonebook entry. a
MOKN
6MbN: Select the desired phone number.
a MOKN
R“Baby Monitor” will be displayed.
Note:
RIf you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
nBy entering phone numbers:
1MMenuN (right soft key) #268
2MbN: “On” a MOKN
3MbN: Select “External” to monitor
from an outside line. a MEditN a
MAddN
4MbN: “Manual” a MOKN
5Enter the desired name. a MOKN
6Enter the desired number. a MOKN 2
times
R“Baby Monitor” will be displayed.
Note:
RThe registered name/number is displayed.

Turning off the baby monitor

The monitored handset cannot be used while
baby monitor is set to “On”.
1Press MMenuN on the handset being
monitored.
28
Programming
PRS110FX(en)_0725_ver020.pdf 28 2013/07/25 9:56:13