2MbN: “On/Off” a MOKN
3MbN: “Off” a MOKN a M N
Editing an outside monitoring number
1Press MMenuN on the handset being
monitored.
2MbN: “On/Off” a MOKN
3MbN: “On” a MOKN
4MbN: Select the outside line. a MEditN
5MMenuN a MbN: “Edit” a MOKN
6Edit the name if necessary. a MOKN
7Edit the phone number if necessary. a
MOKN 2 times
Erasing an outside monitoring
number
1Press MMenuN on the handset being
monitored.
2MbN: “On/Off” a MOKN
3MbN: “On” a MOKN
4MbN: Select the outside line. a MEditN
5MMenuN a MbN: “Erase” a MOKN
6MbN: “Yes” a MOKN a MN
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
RThis feature cannot be set during a
monitoring call.
1Press MMenuN on the handset being
monitored.
2MbN: “Sensitivity Level” a MOKN
3MbN: Select the desired setting. a MOKN
a MN
Answering the baby monitor
nWhen monitoring with a handset:
Press MN to answer calls.
If you want to respond from the monitoring
handset, press MN.
RThe monitoring handset will answer calls
automatically when the auto intercom
feature is set to “On” (page 16).
Note:
RIf you receive an outside call when
communicating with the monitored
handset, you hear 2 tones. To answer
the call, press MN, then press M N.
nWhen monitoring from an outside line:
To answer a call, follow the operation for
your phone.
If you want to respond from the monitoring
handset, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R2 minutes after the monitored handset
starts a call, communication between the
monitored handset and monitoring
phone line is turned off automatically.
Other programming
Changing the handset name
Each handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1MMenuN (right soft key) #104
2Enter the desired name (max. 10
characters).
3MOKN
4MbN: Select the desired setting. a MOKN
2 times a MN
29
Programming
PRS110FX(en)_0725_ver020.pdf 29 2013/07/25 9:56:13