Note:
RTo stop the alarm, press MStopN or place
the handset on the base unit or charger.
RWhen the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Viewing entries
1MMenuN (right soft key) a a MOKN
2To see the entries on the selected date,
press MOKN.
To see the schedule list, press MListN.
RYou can see detailed information
about the schedule by pressing
MMenuN. a MbN: “Detail” a MOKN
Editing an entry
1MMenuN (right soft key) a a MOKN
2MListN a MbN: Select the desired entry.
3MMenuN a MbN: “Edit” a MOKN
4Edit the date if necessary. a MOKN
5Edit the time if necessary. a MOKN
6Edit the text memo if necessary (30
characters max.). a MOKN
7MbN: Select the desired alarm tone. a
MOKN 2 times a MN
Erasing an entry
Schedule alarm entries are not erased
automatically after the schedule alarm sounds.
Erase unwanted entries.
1MMenuN (right soft key) a a MOKN
2MListN a MbN: Select the desired entry.
3MMenuN a MbN: “Erase” a MOKN
4MbN: “Yes” a MOKN a MN
Erasing all entries
1MMenuN (right soft key) a a MOKN
2MListN a MMenuN
3MbN: “Erase All” a MOKN
4MbN: “Yes” a MOKN
5MbN: “Yes” a MOKN a M N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a single
base unit.
Important:
RThe additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when “Auto” is selected on
base unit (page 32), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a “radio cell”.
Note:
RCalls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1Handset:
MMenuN (right soft key) #130
2MbN: Select a base unit number. a MOKN
RThis number is used by the handset as
a reference only.
3Base unit:
Press and hold MN for about 5 seconds.
31
Programming
PRS110FX(en)_0725_ver020.pdf 31 2013/07/25 9:56:13