Panasonic KX-NCP1000 installation manual Select KX-NCP500/1000 from PBX Model

4.3.1Installing and Starting the Maintenance Console

5.Click Connect.

6.a. Select KX-NCP500/1000 from PBX Model.

b.Select the LAN or RS-232Ctab, depending on the type of PC connection with the PBX.

c.Specify the settings as required.

Note

When connecting to the PBX for the first time selecting LAN, the IP Address and Port Number must be set to 192.168.0.101 and 35300 respectively.

d.Enter the system password for installer (default: 1234).

e.Click Connect.

7.Follow the instructions of the Quick Setup wizard and assign the basic items (Quick Setup).

After Quick Setup is completed, if the IP addressing information was not changed and a V-IPEXT card was installed during setup, the IP-PT registration screen is displayed. For information on registering IP-PTs to the PBX, refer to "3.15 [1-1]Slot—Port Property - Virtual IP Extension" in the PC Programming Manual. You may now begin programming the PBX.

CAUTION

Do not remove the SD Memory Card while power is supplied to the PBX. Doing so may cause the PBX to fail to start when you try to restart the system.

Notice

•During a long programming session, it is highly recommended that you periodically save the system data to the SD Memory Card. If the PBX undergoes a sudden power failure or if the system is reset for some reason, all the system data in RAM will be lost. However, if system data has been saved to the SD Memory Card, it can be easily restored.

To save the system data to the SD Memory Card, (1) click the "SD Memory Backup" icon before resetting the PBX or turning off the power, or (2) exit the Maintenance Console so that the PBX automatically saves the system data.

•When programming PBX data which can be displayed on a proprietary telephone (PT) (extension names, group names, System Speed Dialing names, etc.), it is possible to enter characters which cannot be displayed on a KX-DT300/KX-T7600 series PT.

116

Installation Manual Document Version 2011-10