700al australian 2 5 02 2/5/02 3:00 pm Page 11
If you are satisfied with the operation of your telephone service after plugging in your Permitted Attachment, your installation is complete.
You will be unable to connect this Permitted Attachment if your telephone service consists only of a wall phone or an old style telephone which is not connected by means of a modern plug and socket. In such cases a new socket will need to be installed.
Should the Permited Attachment not operate when plugged into a socket, it is either faulty or unsuitable for operation with your telephone service. It should be returned to the store where purchased or the Authorised Service Centre.
Service difficulties
If at any time a fault occurs on your telephone
CHAPTER 1
service carry out the following checks before you call for service:
•Disconnect the Permitted Attachments and try using the service with the normal telephone.
•If the telephone service then operates satisfactorily, the fault is in your Permitted Attachment. Leave the Permitted Attachement disconnected and report the fault to its supplier or agent to arrange for repair.
•If when using the telephone the service is still faulty, report the fault to “Service Difficulties and Faults” for attention.
You are required to keep this Permitted Attachment in good working order while it is connected to your telephone service. Its construction or internal circuit must not be modified in any way without permission.
Wall Mounting
This unit can be mounted on a wall.
WALL TEMPLATE
6cm
6cm
• Install screws using the wall template on page.
• Connect the line cord, and AC Adaptor.
• Arrange the wires as shown, then mount the unit.
11
