Troubleshooting, Initial settings | Panasonic KX-TG1810NZ guide

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 32).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.

The handset display is blank.	LThe handset is not turned on. Turn the power on
	(page 10).

The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 9).
	LFully charge the batteries (page 9).
	LClean the charge contact and charge again (page
	9).

39

Image 39

Panasonic KX-TG1810NZ operating instructions Troubleshooting, Initial settings, Problem Cause & solution

Contents

Model No. KX-TG1810NZ Introduction Phonebook category Feature highlightsNight mode Phonebook Making/Answering Calls Accessory information Included accessoriesAdditional/replacement accessories Environment Battery cautionImportant information General Base unit Charge contact Controls and displaysControls Microphone Display Meaning Icon ConnectionsDisplays Display icons Battery installation Battery chargeBattery strength Battery icon Battery replacement Turning the power on/offSetting the date and time Example 330 PM Making calls Redial feature Other features Answering calls Finding and calling a phonebook entry Using the phonebookAdding entries to the phonebook Categories Erasing all entries Erasing entries from the phonebookOne touch dial Erasing an entry Copying all entries Copying phonebook entries to other handsetsChain dial Copying one entry Handset settings Sub-menu Default setting Menu Guide to handset settings Ringer volume Time settingsRinger setup Alarm Setting the ring delay for night mode Night modeSetting the start and end time for night mode Turning night mode on/off Changing the display language Display setupSelecting the standby mode display Selecting categories to bypass night mode Other options Call options Resetting the handset to its default settings Base unit Sub-menu Default Settings menu Guide to base unit settings Select Base Unit Setup, then press Night mode Setting pause length Changing the recall timeStoring/changing emergency numbers Selecting area codes to be deleted automatically Setting call restriction Changing the base unit PIN Personal Identification Number Resetting the base unit to its default settings Category features for Caller ID subscribers Using Caller ID service Erasing caller information Caller listViewing the caller list and calling back Editing a caller’s phone number before calling back Call minder Additional base units Operating additional unitsRegistering a handset to a base unit Additional handsets Selecting a base unit Cancelling a handset Increasing the range of the base unit Cancelling a base unitTurning the repeater mode on/off Intercom between handsets Transferring calls between handsets, conference calls 60 mm Screws Hooks Wall mounting Character entry modes Available character entries Extended 1 character table N Extended 2 character table OCyrillic character table P Troubleshooting Initial settingsProblem Cause & solution Telephone Useful Information Specifications PIN Index Copyright Customer Support Centre Tel. No 272 Sales Department