Panasonic KX-TG1831NZ specs

Useful Information

Problem	Cause & solution
I fully charged the batteries, but	LClean the charge contacts and charge again (page
7still flashes.	8).
	LIt is time to replace the batteries (page 8).
I fully charged the batteries, but the	LWipe the battery ends (S, T) and the unit contacts
operating time seems to be short.	with a dry cloth.
Caller information is not displayed.	LYou must subscribe to Caller ID service.
	LYour unit is connected to a telephone line with
	ADSL (JetStream) service. We recommend that
	you contact your ADSL service provider to have an
	ADSL Splitter installed. We do not recommend the
	use of generic ADSL filters. Contact your ADSL
	service provider for details.
	LOther telephone equipment such as a monitored
	Burglar Alarm or the modem in the SKY Digital
	decoder may be interfering with this unit.
	Disconnect the other equipment and try again.
While viewing caller information,	LDo not pause for over 1 minute while searching.
the display returns to standby
mode.
I cannot register a handset to the	LThe maximum number of handsets (6) are already
base unit.	registered to the base unit. Cancel unused handset
	registrations from the base unit (page 22).
	LYou entered the wrong PIN number. If you forget
	your PIN, consult your nearest Panasonic service
	centre.
	LPlace the handset and the base unit away from
	other electrical appliances.

28

Image 28

Panasonic KX-TG1831NZ operating instructions LWipe the battery ends S, T and the unit contacts

Contents

Model No. KX-TG1831NZ Introduction Making/Answering Calls Accessory information Included accessories Battery caution Important informationGeneral Environment Controls Important notice Displays ConnectionsBase unit Charge contact B x Ringer Display icons Display Meaning icon If you subscribe to an Adsl service Battery chargeLocation Turning the power on/off Battery strength Battery iconPower on Power off Display language Date and time Redial feature Other featuresMaking calls Erase Pause button for PBX/long distance service users Auto talk featureTo adjust the handset ringer volume when receiving a call Answering calls Handset phonebook Adding entries to the handset phonebookFinding and calling a handset phonebook entry Editing entries in the handset phonebook Chain dial Handset settings Handset Settings Base unit settings Repeater ModeCall Options Recall/Flash Area Code Call Restrict Other Options Base Unit PIN Setting call restriction OK iBase Unit Setup Call Options Area CodeOK iBase Unit Setup Call Options Call Restrict Call options Using Caller ID service Caller listViewing the caller list and calling back OK iCaller List Editing a caller’s phone number before calling back Erasing caller informationStoring caller information into the handset phonebook OK iEdit and Call OK iHandset Setup Registration Register H.set Operating additional unitsRegistering a handset to the base unit Additional handsets Cancelling a handset OK iBase Unit SetupOKiBase Unit Setup Other Options Repeater Mode Increasing the range of the base unit To complete the call transfer, press Characters available in each character entry mode When the unit displays the character entry screenCharacter entry Character entry modes Extended 2 character table O Extended 1 character table NCyrillic character table P Error messages TroubleshootingMemory Full You must first subscribe Problem Cause & solution LWipe the battery ends S, T and the unit contacts Specifications Index PINPage Customer Support Centre Tel. No 272 Sales Department Copyright