Preparation
9
Note:
LIt is normal for the handset to feel warm
during charging.
LIf you want to use the unit immediately,
charge the batteries for at least 15
minutes.
LClean the charge contacts of the handset
and base unit with a soft, dry cloth once a
month, otherwise the batteries may not
charge properly. Clean more often if the
unit is exposed to grease, dust or high
humidity.
Battery strength
Panasonic Ni-MH battery performance
(included batteries)
Note:
LIt is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
LActual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
LBattery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
LEven after the handset is fully charged,
the handset can be left on the base unit
without any ill effect on the batteries.
LThe battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit and charge for at least 7 hours.
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Symbols used in these operating instructions
Battery icon Battery strength
5High
6Medium
7Low
When flashing: Needs
to be charged.
Operation Operating time
In continuous use 17 hours max.
In continuous
standby mode
180 hours max.

Charge

contact

Symbol Meaning
{j/OK}Press {j/OK}.
iProceed to the next operation.
“ ” Select the words in quotations
shown on the display (e.g.,
“Handset Setup”) by
pressing {^} or {V}.
TG1831NZ(e-e).book Page 9 Thursday, June 1, 2006 4:34 PM