Programming

Note:

L To stop the alarm, press any dial key or place the handset on the base unit or charger.

L When the handset is in use, the alarm will not sound until the handset is in standby mode.

L If you select “Once”, the setting changes to “Off” after the alarm sounds.

L When the ringer volume for outside calls is set to off (page 24), the alarm sound is heard at a low level.

Page 27

Image 27

Panasonic KX-TG4391NZ, KX-TG4382NZ, KX-TG4392NZ, KX-TG4381NZ operating instructions Programming

Contents

Operating Instructions Preparation Caller ID ServiceVoice Mail Service Introduction Notable differences between the models Product information Feature differences Model No Answering system Intercom Accessory information Supplied accessoriesReplacement battery information For your safety Battery General noticeRechargeable Ni-MH batteries AAA R03 size Base unit location/avoiding noise Important safety instructionsFor best performance Important notice Introduction Answer on indicator ControlsBase unit Handset Navigator key /V// ? Volume /V Display ConnectionsCharger Battery installation and replacement KX-TG4381/KX-TG4382 Battery chargeBattery level Battery icon Base unit Charger*1 Date and time Setting up the unit before use Belt clip Headset optionalTo attach the belt clip To remove the belt clip Answering calls Making calls Recall Useful features during a callHold Mute To turn dial lock on Dial lockHandset clarity booster Call share Phonebook Adding entriesFinding and calling a phonebook entry Erase iYes iOFF Editing entriesErasing entries Chain dial Main menu Sub-menu Programmable settingsProgramming by scrolling through the display menus Menu Initial setting Set answering Ring count*1 Feature Setting code System Code Setting*1 Programming using the direct commands Access# Time Setting the start and end time Special instructions for programmable settingsNight mode Alarm Programming Using Caller ID service Caller ID featuresRinger ID View CID Caller listViewing the caller list and calling back Storing your area code Storing caller information into the phonebook Editing a caller’s phone number before calling backErasing selected caller information Erasing all caller information Memory capacity Turning off the call screening featureAnswering system Greeting message Erasing your greeting message Using a pre-recorded greeting messageRecording your greeting message Playing back the greeting message Erase Voice guidanceCalling back Caller ID subscribers only Menu Message play i Select Remote operation Remote access codeUsing the answering system remotely Remote commands Answering system settings Turning on the answering system remotelyNumber of rings before the unit answers calls Message alert Caller’s recording time Listening to voice mail messages Voice mail serviceStoring the voice mail VM access number To erase the voice mail access number Voice Mail Service Handset KX-TG4382/KX-TG4391 IntercomMaking an intercom call Answering an intercom call Handset locator Wall mounting To remove the wall mounting adaptor Display message Cause/solution Error messages Troubleshooting General use Problem Cause/solutionProgrammable settings Problem Cause/solution Battery recharge Problem Cause/solution Problem Cause/solutionMaking/answering calls, intercom Caller ID Problem Cause/solution Answering system KX-TG4391/KX-TG4392 Problem Cause/solution KX-TG4382/KX-TG4392 Registration Problem Cause/solutionHandset Menu i#130 KX-TG4381/KX-TG4391 Liquid damage Problem Cause/solution Specifications Index Copyright PNQX1239ZA CM0708PF0For your future reference Sales Department