Display message Cause/solution
Use rechargeable battery. RA wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 5, 8.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.

General use

Problem Cause/solution
The handset does not turn on
even after installing charged
batteries.
RPlace the handset on the base unit or charger to turn on
the handset.
The unit does not work. RMake sure the batteries are installed correctly (page 11).
RFully charge the batteries (page 12).
RCheck the connections (page 11).
RUnplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
RThe handset has not been registered to the base unit.
Register the handset (page 42).
I cannot register a cellular phone
to the base unit.
RDepending on the compatibility of the cellular phone,
you may not be able to register it to the base unit.
Confirm that your cellular phone supports the hands-free
profile (HFP) specification.
RConfirm that the Bluetooth feature of your cellular phone
is turned on. You may need to turn this feature on
depending on your cellular phone.
RThe Bluetooth technology on your cellular phone may
not be functioning normally. Turn off and on your cellular
phone.
RIf your cellular phone is already connected to another
Bluetooth device such as a Bluetooth headset, turn it off
or disconnect it from your cellular phone.
RSome cellular phones may require you to enter the base
unit PIN to register. Confirm that you entered the correct
PIN.
62 For assistance, please visit http://www.panasonic.com/help
Useful Information