Manuals / Panasonic / Lawn and Garden / Lawn Mower Accessory

Panasonic M282737F owner manual Check drain, Fill tank

Models: M282737F

1 33

Download 33 pages 63.46 Kb

Page 25

Operation - Using the Sprayer (continued)

7. Check drain	Before filling tank, ensure drain cap is securely tightened.
cap

Drain cap

8. Fill tank

Add pesticide to tank through fill cap:

a)Confirm the chemical/water dilution ratios specified on the chemical label.

b)Determine chemical and water volumes needed for the planned application, taking into consideration that maximum tank capacity is 16 gallons.

Note: Only purchase and mix as much chemical as you need for the planned application in order to minimize chemical overapplication and the need for storing unused chemicals.

c)Add chemical to the tank through the fill cap.

If the chemical is not pre-mixed, add water and pesticide concentrate in the order prescribed on the label.

CHEM ICAL

),*

9. Ensure	Ensure chemical is thoroughly mixed in tank.
chemical	- Stirring device should be made of metal or plastic, non-chemical absorbing
mixed	material, and then properly cleaned and stored after use.
10. Replace fill	Replace fill cap and tighten securely.
cap

25

Image 25

Panasonic M282737F owner manual Check drain, Fill tank

Contents

M282737F Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended UseDuring Assembly Summary of Important Safety InformationGeneral Chemical Safety Chemical Application SafetyInhalation Chemical accident proceduresDifferently with filled sprayer attached Unpacking Closely inspect all contents in the shipping cartonFollowing items are found in the manual bag Unpacking the Manual BagStep One Attach the tongue to the cart base AssemblyStep Two Attach the hitch mount to the tongue Step Three Attach the cart base to the sprayerStep Five Attach pressure gauge Step Four Attach wheels to cart baseStep Six Attach gun hose to spray gun and pump Step Eight Attach drain cap to tank Step Seven Attach gun clips to tankStep Nine Attach hose guide to tank Preparatory safety Preparatory safety steps Step Eleven Connect power cords to vehicle batteryStep Ten Attach sprayer to vehicle Prepare wire ends Separate powerVehicle battery To install battery clampsPower cord may remain connected to the battery Attach remote switchCheck and test completed assembly Step Twelve Check and test completed assemblyTest with water Test the system for leaks with waterMachine Components General Chemical Safety Operation Important Safety InformationBefore Spraying Chemical Application SafetyDuring Spraying After SprayingChemical accident procedures Towing SafetyInhalation Operation Preparing the Sprayer for Each Use Important safety rulesInspect Inspect and test the sprayer thoroughly Repair Step One Assess wind conditions and clear work area Operation Using the SprayerSpray because the wind is too strong Ensure tank is flushed of all chemicals from prior uses Step Two Fill the sprayerFill tank Check drainStep Three Operate the sprayer Review safetyEnsure flow Through priming HoseOperate spray gun as needed for application Proper Operation of the Spray GunImmediately Open until desired amount of agitation is achievedDrain tank Step Four Clean sprayer and decontaminate after useDecontaminate LaunderStorage Before attempting to service the sprayer TroubleshootingAny Questions, Comments, Problems or Parts Orders SpecificationsExploded View 282737 Rev. F Any Questions, Comments, Problems or Parts Orders