Assembly (continued)
14
Hoop
Prongs
Strip ½”
Red wir
e
Handl
e
shield
2. Identify sprayer’s
power cords Identify the power cords shipped with the sprayer.
There are three power cords for the sprayer that you will eventually connect end to
end to power the sprayer. Locate and identify these three cords:
a) The battery power cord and the pump power cord are sh ipp ed co nn ect ed
together to t he sprayer.
b) The remote switch power cord is packed separately in the Manual Bag.
3. Se parate power
cords Disconnect the battery power cord from the pump power cord.
4. Prepare wire ends Prepare the wire ends of the sprayer’s battery power cord for connection to
the vehicle battery:
a) Determine the type of end connectors you need to connect to your vehicle’s
batt ery t ermi nals .
b) Install bat te ry c l amps (su ppl i ed ) or end conne c tor s of you r c h oos i ng on t he
bare ends of the sprayer’s battery power cord wires.
To install battery clamps:
1. Remove red plastic handle
shield from red battery clamp
and slide onto red wire
2. Strip red battery cord wire ½”
3. Insert bare wire under raised hoop
on red battery clamp handle
4. Use a p lier s to pre s s ho op do wn an d cr imp wir e
5. Fold prongs over wire insulation to hold wire in place
6. Push plastic handle shield back over battery clamp handle
7. Repeat for black wire and black battery clamp.
Batter
y
power cord
Pump p o w er co rd
Remote switch
power cord
Batter
y
power cord
Pump p o w er co rd