Dirt Sensor
Wand Quick
Release Pedal
Pédale de relâche de la rallonge Pedal de liberación rápida del tubo
Cross Section View |
| |
Coupe transversale |
| |
Corte transversal |
| |
Approx. 3 ½ inches or 90 mm | Ring | |
À peu près 3 ½ pouces ou 90 mm | ||
Bague | ||
Aprox. 3 ½ pulgadas o 90 mm | ||
| Anillo | |
Sensor Elements |
| |
Élements détecteurs |
| |
Elementos del detector |
|
Although the dirt sensor feature in your POWER NOZZLE is designed for years of trouble free use, the passage of dirt through the air passage system can coat the lenses causing the green light to come on and stay on - never switching to red. When this hap- pens the lenses must be cleaned.
CAUTION
Never use water or any cleaning solution when cleaning the lenses. The residue of the water or cleaners will accelerate the recoating of the lenses and make cleaning necessary sooner.
TO CLEAN THE LENSES
➢Remove the wand by pressing the quick release pedal and lifting up on the wand.
➢As indicated by the illustration, the two dirt sensor elements are located on the inside of the swivel, approximately 3½ inches/90 mm down, (note the arrows). Each element should be cleaned periodically. To reach the sensor elements, use a small brush such as a bottle brush. Brush each sensor element several times to remove dust and dirt.
NOTE: Looking down inside the swivel you will see a ring. The sensor elements are located just slightly below this ring.
➢Reinstall the wand after cleaning the sensors.
- 46 -