Belt |
Courroie |
Correa |
Motor Shaft |
Arbre du moteur |
Eje del motor |
Carpet/Bare |
Floor Selector |
Shaft |
Arbre d'entraînement |
du sélecteur |
tapis/plancher |
Selector |
|
| Agitator | |
|
| Agitateur | |
|
| Agitador | |
|
| End Cap | |
Motor Shaft |
| Bouchon | |
| Tapa del | ||
Arbre d’entrainement | |||
du moteur | Belt | extremo | |
Eje del motor | Groove | ||
Courroie | |||
| |||
| Correa | Rainure | |
| Ranura | ||
|
| ||
|
| Tabs | |
|
| Languettes | |
|
| Lengüetas | |
2 |
| 1 | |
|
| ||
|
| Slots | |
|
| Fentes | |
|
| Ranuras | |
Four Screws |
Quatre vis |
Cuatro Tornillos |
➢Loop new belt (part number
➢Reinstall agitator back into nozzle by placing end caps into grooves.
➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.
➢Place the vacuum cleaner in the upright position standing on the handle. This will minimize wheel interference when installing lower plate.
➢Reinstall lower plate by (1) aligning tabs on front edge of lower plate with slots in the nozzle and (2) rotating to installed position.
➢Lay vacuum cleaner on the floor with the bottom up and nozzle flat.
➢Install the four screws to the nozzle cover.
➢Route nozzle hose to hose holder. Align nozzle hose bracket with retaining bracket on body and slide down unit it clicks into place.
➢Return the vacuum cleaner to the upright position before plugging into an electrical outlet.
- 46 -
