When Recording Over the Same Location on a Tape:
–The originally recorded programme is deleted from the list.
–Programme contents starting near the start and end of the newly recorded programme (within 10 minutes before the start and after the end of the newly recorded programme) are also erased.
(Although old programme contents are also similarly erased in the case of ordinary recording, the newly recorded programme is not registered in the list.)
|
| Erased | |
|
|
| |
Programme 1 | Programme 2 | Programme 3 |
|
|
|
|
|
New programme 
Within 10 minutes
Erased
Programme 1 | Programme 2 | Programme 3 |
|
|
|
New programme
Within 10 minutes
Not erased
Programme 1 | Programme 2 | Programme 3 |
|
|
|
New programme
10 minutes or more
To Demonstrate the Jet Navigator Function
Keep the NAVI button 4 pressed for more than 5 seconds without inserting a cassette tape.
To Check the Recorded Programming Data (Time Stamp Function)
To Find the Beginning of Each Recording (VHS Index Search System)
This VCR automatically records special index signals on the tape every time a recording is started. The Index search function makes use of these index signals to let you find the beginning of a desired programme quickly and easily.
Index signals are automatically recorded in the following cases:
–When you start a recording by pressing the REC button I, REC/OTR button Z, or DIRECT REC button Q.
–When a timer recording starts.
–When you press the REC button I on the remote control during recording.
Conditions for correct operation of the Index search function:
–The VCR must be in the stop mode or in the playback mode.
–Each programme recorded on the tape must be at least 5 minutes long.
Preparations
–Display the VCR picture on the TV.
–Insert a recorded video cassette.
Operation
1Press the INDEX button L (that corresponds to the direction from the current tape position in which the desired programme is located on the tape) to start the index search.
For example, if you want to search for the 2nd recorded programme in forward direction, press the INDEX L button L twice.
–The VCR
When it has been found, playback starts automatically.
When playback starts after searching with Jet Navigator function or index search function, recorded programming data (called Time Stamp) appears on the TV screen for approx. 5 seconds.
Preparation
–Display the VCR picture on the TV.
Note:
On Screen Display
CH 2 | 10/27. SA ON 20:02 |
To Cancel the Index Search or to Stop Playback: Press the Stop button F.
Notes:
– Searching in either direction is possible up to the 20th |
index signal. |
– If you press either of the INDEX button L too many times, |
simply press the other INDEX button L (indicating the |
opposite direction) to correct it. In this way, you can reduce |
–Time Stamp does not appear if the beginning of the Jet Navigator data are not recorded 10 minutes before and after the current tape position even when index signals are recorded.
the displayed figure down to 1. |
– The figure on the VCR display decreases by 1 every time |
an index signal is located. |
24
