OPTION menu
INSTALLATION
When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See “Projection method” on page 15.
FRONT/DESK | Setting on a desk/floor and | |
projecting from front | ||
| ||
FRONT/CEILING | Mounting on the ceiling and | |
projecting from front | ||
| ||
REAR/DESK | Setting on a desk/floor and | |
projecting from rear | ||
| ||
REAR/CEILING | Mounting on the ceiling and | |
projecting from rear | ||
| ||
|
|
SLEEP
You can select the required duration of time and set the off timer to turn off the power of the projector automatically. 3 minutes before
OFF |
|
| 240MIN. |
|
| ||
|
|
|
|
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH ALTITUDE MODE setting need to be ON to set the fan speed high. Press I H to select the required option.
OFF | The fan speed is low. |
ON | The fan speed is high. |
NOTE:
•At 1 400 - 2 700 m (4 593 - 8 858 ft) above sea level, the setting must be ON.
•The loudness of fan noise depends on the HIGH ALTITUDE MODE setting.
LAMP POWER
You can adjust the power of the lamp to save on electricity, prolong the lamp life and reduce the noise.
Options | Function | |
|
| |
NORMAL | When higher luminance is | |
required. | ||
| ||
|
| |
| When lower luminance is | |
sufficient. | ||
| ||
|
|
60MIN.
90MIN.
120MIN.
210MIN.
180MIN.
150MIN.
NOTE:
•When no input signal is detected, the function is disabled.
LAMP RUNTIME
You can check how long the lamp has been used.
Settings
NOTE:
•LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Replacing the lamp unit” on page 47.
