Projection, Powering up the projector | Panasonic PT-D4000U specification

Projection
R/PR G/Y B/PB		SYNC/HD VD
VIDEO IN S-VIDEO IN	RGB 1 IN
REMOTE 1	REMOTE 2 IN	IN	SE
IN OUT

Powering up the projector

When using an optional lens, install a projection lens before powering up the projector. (Refer to page 24.)

Remove the lens cover beforehand.

Connect the supplied power cord. (120 V AC, 50 Hz/60 Hz)

Press the “ I ” marked side of the MAIN POWER switch to turn on the power.

The power indicator lights up red, and the projector is placed in the standby mode.

Press the “ I ” button. [on the main unit or the remote control]

The power indicator illuminates in green and soon the image is projected on the screen.

Making adjustment and selection

It is recommended that the projector be allowed to warm up for at least 30 minutes before any adjustments are made to the focus.

Press the FOCUS button to roughly adjust the focus of the lens.*

Set the projection scheme in “INSTALLATION” setting. (page 34)

Select the input signal by pressing the input selector button to toggle through RGB1, RGB2, VIDEO, S-VIDEO and DVI-D.

Turn the feet, and adjust the tilt of the main unit in the front and rear or left and right.

Note • If the projector is powered up at about 0 ˚C, a warm-up period of approximately five

minutes may be necessary to start projection.

The temperature monitor (TEMP) lights during the warm-up period.

When the warm-up is completed, the temperature monitor (TEMP) turns off and the image is projected on the screen.

•If the surrounding temperature is very low and the warm-up period exceeds five minutes, the control determines it as an abnormal condition and turns off the power automatically. If this happens, raise the surrounding temperature to 0 °C or higher and then turn the main power “on” and turn the power “on” ( ).

Use the lens left/right adjustment dial to adjust the direction of the lens. (page 25)