Panasonic PT-DW5100EL, PT-D5700E OPTION1 settings, Color Matching, Press to select R, G, B and Wh

OPTION1 settings

OPTION1
	COLOR MATCHING	OFF
	COLOR CORRECTION	USER
	CONTRAST MODE	NORMAL
	AUTO SIGNAL	OFF
	BACK COLOR	BLUE
	STARTUP LOGO	OFF
	SUB MEMORY LIST
	DVI EDID	EDID2:PC
	DVI SIGNAL LEVEL	0-255:PC
	FUNC1
	OSD POSITION	1
	OSD MEMORY	ON
	MENU SELECT
	CHANGE

COLOR MATCHING

When multiple sets are used simultaneously, this projector allows the user to correct the difference of colours among the sets.

Press to select “COLOR MATCHING”.

Press to switch “COLOR MATCHING”.

The setting will change as follows each time is pressed.

OFF : Colour matching adjustment is not carried out.

3COLORS : It is possible to adjust the 3 colours of “R (Red)”, “G (Green)” and “B (Blue)” and “Wh (White)”*.

*When “3COLORS” is selected, only the brightness can be adjusted for “Wh”.

7COLORS : It is possible to adjust the 7 colours of “R (Red)”, “G (Green)”, “B (Blue)”, “Cy (Cyan)”, “Mg (Magenta)”, “Ye (Yellow)” and “Wh (White)”.

MEASURE : Refer to “Adjusting the colour matching using a colourimeter” on the right for details on these modes.

If “3COLORS” or “7COLORS” was selected in step 2.

Press the ENTER button.

The “COLOR MATCHING: 3COLORS” or “COLOR

MATCHING: 7COLORS” screen will be displayed.

Press to select “R”, “G”, “B” and “Wh”.

(“R”, “G”, “B”, “Cy”, “Mg”, “Ye” and “Wh” when selecting “7COLORS”.)

Press the ENTER button.

Press to adjust the values.

These values can be adjusted from 0 to 2048.

(If the default value of the colour is 2048, the value can be adjusted from 256 to 2048.)

Note • The effects of correcting the adjustment colour

When tuning the correction colour that is the same as the adjustment colour

:The brightness of the adjustment colour changes.

When tuning the correction colour RED

:RED is added to or reduced from the adjustment colour.

When tuning the correction colour GREEN

:GREEN is added to or reduced from the adjustment colour.

When tuning the correction colour BLUE

:BLUE is added to or reduced from the adjustment colour.

•This adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is required to make successful adjustment.

•Pressing the DEFAULT button will restore the factory defaults for all items.

•When any setting other than “OFF” has been selected for “COLOR MATCHING”, “AI”, “COLOR CORRECTION” and “COLOR TEMP” settings are not adjustable.

•When “AUTO TESTPATTERN” is set to “ON”, the test pattern for adjusting the adjustment colour is automatically displayed.

Adjusting the colour matching using a colourimeter

The “R (Red)”, “G (Green)”, “B (Blue)”, “Cy (Cyan)”, “Mg (Magenta)”, “Ye (Yellow)” and “Wh (White)” colours can be changed to the desired hues using a colourimeter which is capable of measuring the chromaticity coordinates and luminance.

Inputting the current luminance and chromaticity coordinates

Press to select “COLOR MATCHING”.

Press to select “MEASURE”. Press the ENTER button.

The “COLOR MATCHING:MEASURE” screen will be displayed.

Press to select “MEASURED DATA”. Press the ENTER button.

The “MEASURED DATA” screen will be displayed.

Use the colourimeter to measure the luminance (Y) and chromaticity coordinates (x, y).

Press to select the colours, and

press to select their values.

ENGLISH

(Continued on the next page)

33