Panasonic PT-L759XU, PT-L759VU manual VIDEO/VIDEO Signal Format Selection, Setting procedure

Signals that can be Input

S-VIDEO/VIDEO Signal Format Selection

If the correct signal format is not selected and the picture does not appear normal when VIDEO or S-VIDEO signal is being input, select the format by the following procedure. This function is set to “AUTO” at the time of shipment from the factory, so that the Projector can normally be used with this setting.

• Setting procedure

1 Press MENU to display the menu.

2 Press or to select “Video System”, and then ENTER to display the screen.

P i c t u r e

V i d e o S y s t em

F u n c t i o n

L a n g u a g e

I n f o r ma t i o n

: S e l e c t EN T ER : E n t e r MENU : E s c a p e

3 Press or to switch the setting to “AUTO”, “NTSC”, “NTSC4.43”, “PAL”, “PAL-M”,“PAL-N”or “SECAM” until a

normal picture is obtained.

AU TO

N T SC

N T SC 4 . 4 3

PA L

PA L - M

PA L - N

S ECAM

: S e l e c t MENU : E s c a p e

Note

•Press MENU to remove the setup screen and menu.

•If using a signal source with poor picture quality, such as a dubbed tape, it may not be possible to get the picture to display properly.

•NTSC and PAL-M have the same scanning frequencies and color sub-carrier frequencies, but they have different color modulation methods. Because of this, if the incorrect setting is selected, color pictures may appear in black- and-white.

28