POWER OFF TIMER
If no signal is input to the projector for the duration of the period you set, the projector will return to standby mode. The period can be set from 15 minutes to 60 minutes in 5 minute intervals. If you don’t use this feature, set it to “DISABLE”.
DIRECT POWER ON
This sets the projector’s start up status for when the power cord is connected.
OFF
The projector will start from the same status as when the power cord was disconnected. If the power cord was disconnected during projection when the projector was used the last time, projection will start after the power cord is connected.
ON
The projection will start after the mains lead is connected.
CONTROL PANEL
To disable the buttons on the projector, set “CONTROL PANEL” to “INVALID”. A confirmation screen will then be displayed. Select “OK” by using I or H button. To use the buttons on the projector, set to “VALID” by using the remote control unit.
AUTO SETUP
This should normally be set to “AUTO”.
AUTO
“AUTO SETUP” will be carried out when the input signal is changed to RGB.
BUTTON
“AUTO SETUP” will function only when you press the AUTO SETUP button.
SIGNAL SEARCH
This should normally be set to “ON”. |
| |
ON |
| |
settings | ||
projector detects which signals are | ||
When the power is turned on and |
| |
“AUTO SETUP” is running, the | and | |
being input, and uses these signals | ||
| ||
for projection. | Adjustments | |
(If a picture is being projected, the | ||
| ||
signal source is not automatically |
| |
changed.) |
| |
OFF |
| |
Use this setting when you do not |
| |
| ||
want the signal source to be |
| |
changed automatically when the |
| |
power is turned on and “AUTO |
| |
SETUP” is running. |
|
