Connector panel
How to open
| - |
% & | ' ( * + |
Setting-up
Projection methods
In way of installing projector, any one of the following four projection methods are used. Select whichever projection method matches the
Gettingstarted | |
# $ | ) | , |
Menu items | Setting |
|
|
FRONT/REAR | FRONT |
Menu items | Setting |
|
|
FRONT/REAR | FRONT |
#MAIN POWER switch (pages 22 and 24)
$Power input socket (AC IN) (page 22)
The accessory mains lead is connected here.
Do not use any mains lead other than the accessory mains lead.
|
(pages 19 and 39) |
This connector is used to input |
signals from a |
equipment such as a video deck. |
The connector is S1 signal |
compatible, and it automatically |
switches between 16:9 and 4:3 |
aspect ratios in accordance with the |
DESK/CEILING DESK |
DESK/CEILING CEILING |
%SERIAL connector (pages 19, 20 and 60)
This connector is used to connect a personal computer to the projector in order to externally control the projector.
&RGB1 IN connector (pages 19 and 20)
This connector is used to input RGB signals and YPBPR signals.
'RGB2 IN/RGB1 OUT connector (pages 19, 20 and 42)
This connector is used to input or output RGB signals and YPBPR signals. Use the RGB2 SELECT item in the OPTION1 menu to select whether you want input or output with this connector.
type of signal being input. |
)VIDEO IN jack (page 19)
This jack is used to input video signals from a video equipment such as a video deck.
*AUDIO IN
+Remote control signal receptor (page 21)
,Menu operation (on connector panel)
(page 14)
-Remote control unit holder Store the remote control unit as shown in the figure above.
Menu items | Setting |
| Menu items | Setting |
|
|
|
|
|
FRONT/REAR | REAR |
| FRONT/REAR | REAR |
|
|
|
|
|
DESK/CEILING | DESK |
| DESK/CEILING | CEILING |
|
|
|
|
|
NOTE:
BYou will need to purchase the separate ceiling bracket
BIf you set up the projector vertically, it may cause to damage the projector.
BIt is recommended that you set up the projector
in a place that is tilted at less than ±30°. Setting up the projector in places that are tilted at more than ±30° may cause malfunctions.