Panasonic PT-LM1U Bright, Tint, Sharpness, Color Temp, Tv-System, Still Mode, Signal Mode

BRIGHT

This adjusts the darker areas (black areas) in the picture.

Black areas are too light: I button

Dark areas are too solid: H button

COLOR

(S-VIDEO/VIDEO/YPBPRonly) The color is too deep: I button The color is too pale: H button

TINT

(NTSC/NTSC 4.43/YPBPR only) This adjusts the flesh tones in the picture. The flesh tones are greenish: I button The flesh tones are reddish: H button

SHARPNESS

To soften the picture details: I button

To sharpen the picture details: H button

COLOR TEMP.

COLOR TEMP . STANDARD

[

HIGH

[�

LOW

This is used to adjust the white areas of the picture if they appear bluish or reddish.

White balance R/G/B (W-BAL R/G/B)

(RGB only)

This is used to adjust the white areas of the picture if they appear colorised.

To make the selected color lighter : I button

To make the selected color stronger : H button

AI

AION

[

OFF

ON

The lamp is controlled according to the input signals to project images with the best quality.

OFF

“AI” is disabled.

NOTE:

B“AI” is disabled when “LAMP POWER” is set to “LOW”. (Refer to page 43.)

TV-SYSTEM

(S-VIDEO/VIDEO only)

TV - SYSTEM AUTO

[

NTSC

[

NTSC4 . 43

[

PAL

[

PAL - M

[

PAL - N

[

SECAM

This should normally be set to

“AUTO”. If the signal is of such poor quality that the correct format cannot be automatically distinguished, change the setting manually to the required TV system.

NOTE:

BWhen set to “AUTO”, the projector automatically distinguishes between NTSC/NTSC 4.43/PAL/PAL60/ PAL-M/PAL-N/SECAM signals.

STILL MODE

STILL MODE	OFF
	[
	ON

To reduce flickering of still images (vertical flicker), set “STILL MODE” to “ON”.

NOTE:

BDo not set “STILL MODE” to “ON” when playing back moving images.

SIGNAL MODE

(RGB/YPBPR only)

This displays the type of signal which is currently being projected.

Refer to the table on page 58 for details on each type of signal.

Projecting sRGB-compatible pictures

sRGB is an international color reproduction standard (IEC61966-2-1) established by the International Electrotechnical Commission (IEC). If you would like the colors in sRGB- compatible pictures to be reproduced more faithfully, make the following settings.

#Press the F or G button to select “PICTURE MODE”, and then press the I or H button to select “NATURAL”.

$Press the STD (standard) button on the remote control unit.

%Press the F or G button to select “COLOR TEMP.”, and then press the I or H button to select “STANDARD”.

NOTE:

BsRGB is only enabled when RGB signals are being input (when “LAMP POWER” is set to “HIGH”).

Adjustments and settings

36-ENGLISH ENGLISH-37