Correcting the image position automatically (AUTO SETUP)
This projector can adjust the position of the image and the settings for “DOT CLOCK” and “CLOCK PHASE” when PC signals are being input.
|
| Press the AUTO SETUP button while PC signals |
POWER INPUT | MENU | are being projected. |
|
|
Turning off the picture and sound momentarily (SHUTTER)
The “SHUTTER” function can be used to momentarily turn off the picture and sound from the projector when the projector is not being used for short periods of time, such as during breaks in meetings or when carrying out preparation. The projector uses less power in “SHUTTER” mode than it does in normal projection mode.
| ENTER |
|
AUTO |
| Screen |
SETUP |
|
|
STD |
|
|
| SHUTTER | Projected |
|
| |
RETURN | VOLUME | image |
ENTER |
POWER INPUT | MENU |
ENTER
AUTO
SETUP
STD
Press the SHUTTER button.
BThe picture and sound will be turned off.
BPress any button on either the projector or remote control unit to return to normal operating mode.
ROTATE | BAutomatic positioning | [ |
| ||
| will be carried out. |
|
NOTE:
BIf the dot clock frequency is 100 MHz or higher, “DOT CLOCK”, and
“CLOCK PHASE” will not be adjusted automatically. Refer to page 48 for details.
BIf the edges of the projected image are indistinct, or if a dark picture is being projected, the automatic setup processing may stop automatically before it is complete. If this happens, project a different picture and then press the AUTO SETUP button again.
SHUTTER
RETURN
ENTERVOLUME
ROTATE
Adjusting the volume (VOLUME)
|
| Press the VOLUME +/- button. |
POWER INPUT | MENU | BPress the + button to raise the volume. |
| ENTER | BPress the - button to lower the volume. |
|
|
AUTO
SETUP
STD
SHUTTER
RETURN
ENTERVOLUME
ROTATE
Useful functions