Turning off the power

#, $POWER button

POWER INPUT

MENU

AUTO

SETUP

RETURN

ROTATE

ENTER

STD

SHUTTER

ENTERVOLUME

Direct power off function

You can disconnect the power cord during projection or immediately after use and move the projector. The cooling fan will operate by the internal power supply to cool down the lamp.

BWhen this function is used, it may take more time for the lamp to turn back

on again compared to when the lamp cools down with the power cord

% Power cord

#Press the POWER button.

BThe “POWER OFF” confirmation screen will be displayed.

POWER OFF [POWER] OK

connected.

BDo not put the projector in the softcase while the POWER button on the

projector is illuminated.

NOTE:

BDo not disconnect the power cord while the files in the SD memory card are being played back.

CAUTION

If not using the projector for an extended period of time, disconnect the power cord plug from the wall outlet.

BIf dust builds up on the power cord plug, the resulting humidity may

damage the insulation, which could result in fire.

BThis projector continues to draw approximately 3 W of power even when

Basic operation

$Press the POWER button again.

BThe lamp unit will switch off and the picture will stop being projected. (The POWER button on the projector will illuminate orange while the cooling fan is still operating.)

NOTE:

BPress any button other than the POWER button to cancel the “POWER OFF” screen.

BThe “POWER OFF” screen will disappear in five seconds.

%Disconnect the power cord after the POWER button on the projector illuminates red.

NOTE:

BYou can also turn off the power by holding down the POWER button for at least 0.5 seconds.

the power is turned off.

POWER button on the projector

POWER button status

Projector status

Red

Illuminated

The projector is in standby mode and image projection

is possible by pressing the POWER button.

 

 

 

 

 

 

 

The projector is preparing for projection after the

 

Flashing

power has been turned on while the POWER button

Green

on the projector is illuminated red. (After a short

 

 

 

period, a picture will be projected.)

 

Illuminated

A picture is being projected.

 

 

 

 

 

The lamp is cooling down after the power has been

 

Illuminated

turned off or while direct power off function is

 

 

operating.

Orange

 

 

 

The projector is preparing for projection after the

 

Flashing

power has been turned on while the POWER button

 

on the projector is illuminated orange. (After a short

 

 

 

 

period, a picture will be projected.)

28-ENGLISH

ENGLISH-29

Page 15
Image 15
Panasonic PT-P1SDU operating instructions Turning off the power, #Press the Power button, $Press the Power button again