Panasonic PT 61DLX75 manual First Time Setup, Language, Auto program

First Time Setup

For your convenience, First Time Set up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures displayed on-screen for setting up the features.

Language

The language of the on-screen display is set to English as the factory setting.

You can select English, Spanish or French as the on-screen displays language.

2

3

CH

VOL OK VOL

CH

CH

VOL OK VOL

Press to select “ANT In”.

Press to select “Cable” or “Antenna”.

Auto	program
ANT	In		◄	Cable ►
Mode				All
Start		scan

Press to select Mode.

1

2

3

CH

VOL OK VOL

CH

CH

VOL OK VOL

CH

RETURN

Press to select “Language”.

Press to display Language screen.

First time setup

Language

Auto program

Press to select “English,” “Español” or “Français”.

Language

Language ◄ English ►

Press to go to previous screen. Or, select icon, then press OK for same results.

4

CH

CH

VOL OK VOL

CH

Press to select “All” or “Analog”.

Auto	program
ANT	In			Cable
Mode			◄	All ►
Start		scan

Press to select “Start scan”.

Press to start. Channels available for reception will be set automatically.

Auto program

ANT In	Cable
Mode	All

Start scan

Now scanning analog channel ...

Progress

Basic Operation

Auto program

You can scan All (Analog and Digital) channels. If needed, follow the menus and procedures displayed on-screen for setting up the features. You can also make the settings in Setup menu.

5 After Auto Program is complete, the unit will return to Manual Program mode. To place the channels that were located by auto scan in memory, move the cursor to “Apply” and press OK. (pp. 30-31).

If OK is not pressed after selecting OK, the channels will not be memorized.

1 CH

VOL OK VOL

CH

Press to select “Auto program”.

Press to display Auto program screen.

First time setup

Language

Auto program

Notes:

•After “Auto program” is completed the unit tunes to the first channel found during “Auto program”.

•If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then try “Auto program” again. (p. 29).

•“Auto program” must be done when you select the input signal for the first time or whenever you change the antenna configuration.

•Depending on conditions, “Auto program” may take a while.

25