Panasonic PV-D4753S manual VCR Operation

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again.

Review, Replace or Clear Program Contents:

(Recording is not in progress)

	Press PROG
1 to display Program List.
2		DT	START STOP		CH	SPD	Press
		7	9 : 00A 12 : 00A 08			SP	to select number and
	10		8 : 00P 9 : 00P		10	SP
	8		10 : 00P 12 : 00P 02			SP
		SU	9 : 00P 10 : 00P		L1	LP	press SET
		CANCEL : ADD / DLT					to display.
		SELECT		1-8 :
		ENTER		: SET
		EXIT		: PROG

To cancel a Timer

Recording in progress...

Hold down STOP in VCR mode for a few seconds to cancel the Timer Recording.

(The “TIMER” Indicator goes out on Multi Function Display.)

•Any future daily or weekly recording will be performed as programmed.

3 To Replace program...

DATE		START	STOP		CH	Repeat Step 2 (p. 24)
7 SUN		9:00A 12:00A			08
						to set new programs.
TODAY					SP
	----------------------------------------
SELE CT START DATE
SELECT		:
SET		: SET		BACK :
END		: PROG

or

To Clear program...

DT	START	STOP	CH	SPD Press ADD/DLT.
--	-- : --	-- : --	--	--
8	10 : 00P 12 : 00P		02	SP

108 : 00P 9 : 00P 10 SP SU 9 : 00P 10 : 00P L1 LP

CANCEL : ADD / DLT

SELECT 1-8 :

ENTER : SET

EXIT : PROG

4 Press PROG

to end the programming.

Notes

•If you are using a Cable Box, the VCR’s channel for Timer Recording must be set to the Cable Box input channel and Cable Box must be manually set to the desired channel. Cable Box power must be left on.

•2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER REC” appears and Timer Indicator flashes.

Be sure a cassette with record tab is loaded and DECK is in Stop mode.

•If a power interruption occurs while programming the timer, the timer program(s) may be canceled. If “TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION” appears on-screen, please re-enter the timer programs.

•If the start time for Timer Recording comes up during recording and playing back, Timer Recording will not be performed.

Important notes when using DSS Receiver

•When recording programs via DSS Receiver, DSS Receiver must be left on.

•When recording programs via an antenna or cable, DSS Receiver must be turned off.

VCR Operation

25